Pressure Washer Pull Cord Will Not Start

The solution to this is to use a carburetor cleaning agent.

Pressure washer pull cord will not start.

The end result is a carburetor that does not work and a pressure washer that does not start. After that with each consecutive pull it will be even harder and soon enough the cord will break under the pressure. Flushing the carburetor out with a special cleaning agent should remove the residue and allow the power washer to start. If the pressure washer does not start on that first pull you will be adding more and more with each pull.

This pressure washer had a stuck pull rope. Honda power washer when you shut down your presure washer the pump makes pressure before y. Over time some of the ingredients in the fuel may evapo rate leaving behind a thicker stickier substance. Pressure washer pull cord locked up honda gcv160 won t pull stuck.

If you tipped the pressure washer on its side recently oil may have filled the cylinder preventing the engine from spinning. This sticky fuel can clog up the carburetor and prevent the engine from starting. Took a look at the pull rope assembly to see what was jammed or bent or broken. When a pressure washer pull cord snaps on a job it is a real pain.

A clogged carburetor is most commonly caused by leaving fuel in the pressure washer for a long period of time. If the starter rope won t budge when you try to pull it the engine may be locked up or the recoil starter may have failed. No ned to panic this short video by paul crosbie at spinaclean will show you how to save.